2001 Toyota Tundra Metal Shavings In Transmission Pan

At this point you should be able to see the back of the transmission There is a rear cover on the transmission that you can remove without dropping the transmission at all.

2001 toyota tundra metal shavings in transmission pan. Here is a photo of the shavings that were on it. The contact owns a 2001 Toyota Tundra. Then get the fluid to the correct temperature 115-135 Remove drain plug.

Our Hi-Tek deep transmission pans are constructed from A356-T6 aluminum and are cast with thick internal and external fins adding additional strength and increased cooling properties. On Sunday I finally dropped the trans oil pan on my 2001 Sequoia with 106K miles. Put the car on ramps and locate the transmission drain plug.

So far im thinking this is the process I warm up the fluid by switching to all gears while parked. In my opinion this was a complete waste of time. Jack up the front drivers side of the car.

The filter is also situated below the pickup tube which connects to the oil pump. The most recently reported issues are listed below. First time DIYs are shocked when they drop the transmission pan and find metallic shavings on a transmission magnet.

A less laborious DIY service is to do a drain and refill. Glue some magnets to the bottom of. After dropping the transmission pan it was determined that the pan had several clumps of metal shavings and the transmission has to be replaced.

2001 Toyota Tundra SR5 47L TCC Sl Solenoide Posted to Asian Transmission on 6292004 1 Reply Aloha everybody this toyota truck came in the shop w the TCC solenoid on the on position the computer is sending 12 volts constantly and is energising the solenoid I removed the pan and found some metal shavings but I dont think this has nothing to do w. Keep an eye on the in line filter. The purpose of the transmission filter is to collect any contaminants in the lubricating fluids such as dirt and debris preventing them from being sent into the transmission.