2001 Toyota Tundra Removing Upper Ball Joint

4-the three upper strut mounting nuts.

2001 toyota tundra removing upper ball joint. After that I took the big C-Clamp positioned it around the upper ball joint with the longer catch cup from the 4WD adapter set then I used a 27 mm socket on top in place of the supplied part from the press you may have to pull it out from the wheel well to get it positioned right. 538591Replace the forcing screw in the C-frame with OTC No. Remove the old ball joint and discard.

SEQUOIA 2WD4WD 2001-2007 LAND CRUISER 200 SERIES 4WD 2008 LANDCRUISER 100-SERIES 1998-2007 LEXUS. Clean up the area with some sandpaper dirt loose rust etcand put the new joint in. Especially designed for heavy-duty wear and tear these ball joints will handle the toughest work you can throw at them and.

OE Replacement Warranty. Assemble the ball joint press over the control arm as shown in Figure 3. Turn the forcing screw until the removing adapter meets.

The wheel remained under the vehicle attached to the front drive shaft. 2006 2x4 Tundra OEM torque specs needed. The other cup goes over the pivot.

Front Driver or Passenger Side Upper Recommended Use. This video is only for 1st gen Tacoma 1st gen Tundra and 3rd gen 4Runner only. 2-lower control arm frame bolts.

Toyota Tundra 2011 Front Upper High Travel Replacement Ball Joint by Fabtech. Remove the three bolts securing the ball joint to the control arm using the 38-inch drive ratchet and a socket. 1ST GEN TOYOTA TUNDRA 2000-2006.