2007 Toyota Tundra Front Bumper Removal

Parts like Front Bumper Bumper Stay are shipped directly from authorized Toyota dealers and backed by the manufacturers warranty.

2007 toyota tundra front bumper removal. From underneath the truck remove the 3 bolts 10mm along the bottom edge of your bumper. THIS STEP IS OPTIONAL. The bumper brackets support the bumper parts and locate them properly in relation to the body.

Rear Bumper Bumper Stay are shipped directly from authorized Toyota dealers and backed by the manufacturers warranty. Toyota Tundra with Steel Bumper without Park Assist Sensors without Tow Hook without Fog Lights 2007 Front Upper Bumper Cover by Replace. A Open the bonnet and look for one 13mm nut on the lower inside of each headlight.

Discussion Starter 1 May 16 2010. Modify the support bar by trim-ming the forward facing leg from the part save for reuse. 2 RedRock 4x4 5-Inch Oval Straight End Side Step Bars.

Remove the plastic clip that sits behind the license plate. Using a screwdriver or clip remover remove the 2 pin hold clipstop and bottom and the 2 plastic clips middle. B Remove the towing eye covers on the lower section of the bumper and you will find one 13mm nut in each.

Next unbolt and remove the grill. There are two 17mm bolts along the bottom side of each hook that need to be removed. If you wish to remove the entire set up from the frame remove the bolts attaching the brackets to the frame rails.

Remove the Left and Right ends Pannels underneath the head lights first 2. Remove the left and right Front Bumper Side support. We recommend reading through the installation instructions in whole before performing the work.