Toyota Tundra Air Injection Pump Bypass

Replacing the AIP driver should have fixed it.

Toyota tundra air injection pump bypass. A crafty Toyota driver has engineered an air injection pump bypass module that tricks the trucks computer thinking the pumps and valves are working. 2008 Tundra 57L was in limp mode due to CEL being on code P2445 I found water in air injection pump regulator on bank 1 and had corrosion in the valve assembly so would obviously need new valve and air pump which was around 1200 cost in parts alone. Although the vehicle has only 30330 miles and Ive never off-roaded or abused the truck in any manner its repair record.

I checked it with the code reader at a local shop and. As Steve told you the AIP mod wont fix that one. Mechanic says it will cost 2600 dollars to replace two air injection pumps due to possibl.

My 2007 Toyota Tundra went into Limp Mode when multiple dash warning lights came on. My situation is I cannot or will not shell out money to a dealer to replace a shoddy design by Toyota. The module itself is wired into the mass air flow MAF sensor harness and it gives your Tundras engine computer the impression that the air injection system isnt needed.

Update The blank plug caps are now shipping with the units. TUNDRA AIR INJECTION PUMP VIN xxx Dear SirMadam. Instead of costly repair to replace air injection pumps etc.

Everything else can be removed without any addons the pumps the air tubes and the air injection drivers. We currently only cover the 07-09 Tundra 47L and 08-09 Seq. P2445 is an air Pump Stuck Off failure which is a associated with the Air injection driver.

I also changed. This video will help you install the Air Induction Pump Bypass Module in a Toyota Sequoia or Tundra that can be purchased on Ebay. The Secondary Air System Air Induction System shows that it has completed and is functioning properly.